White Rodgers 1F85RF-275 Guía de instalación descargar pdf (Pagina 20)

Corrective Action

Antenna wire must be installed into the wall

Thermostat and sensor must be at least 5 feet above the

floor

Relocate thermostat or sensor

Relocate thermostat or sensor away from obstacle

If thermostat is indicating that it is receiving, the remote is

transmitting. If you wish to have the remote sensor

display show Temperature and Transmitting icon, change

the User Configuration Menu, item 4 from OFF to On

TROUBLESHOOTING

White-Rodgers is a division

of Emerson Electric Co.

The Emerson logo is a

trademark and service mark

of Emerson Electric Co.

www.white-rodgers.com

www.emersonclimate.com

HOMEOWNER HELP LINE: 1-800-284-2925

Symptom

Poor Communication

between sensor and

thermostat

Remote sensor display

shows only PWR and On.

Transmitting icon does not

appear. In Learn mode,

Transmitting icon and

Learn icon do not appear

Possible Cause

Antenna were installed improperly

Thermostat and/or sensor not at proper

height

Thermostat or sensor may be too close to a

wireless device or noise producing device

Thermostat or sensor may have obstacles

in wall

Remote sensor is configured to have

display OFF

Communication Diagnostic

The thermostat will monitor the integrity of the communication between the thermostat, receiver and wireless remote sensors. When the

thermostat detects a potential communication problem, the LED will flash to indicate a failure code. The LED will flash at 1/2 second On/

Off with a 2 second pause. If more than one error occurs, the highest priority warning will be shown until it is resolved. The indication of

the codes is listed below in the highest priority order.

Possible Cause

Power Mode Switch S7 set to RC and common wire not

connected to C terminal.

Receiver antenna not positioned properly

Poor remote sensor location or orientation

Noisy environment

Radio interferring signal

To prevent this error indication press and hold RUN for 4

seconds to override. Override will be cleared on power-up.

Receiver not programmed (learned) to sensor

Other remote sensor operating on same RF frequency

channel

Receiver installed improperly

Receiver module inoperative

Remote sensor battery dead

Remote sensor has been moved or removed

Remote sensor battery dead

Remote sensor has been moved or removed

Local sensor temperature sensing circuit malfunction.

Code

(Flashes)

Indication

24 VAC lost or not present (receiver will turn off and stop

communication with wireless remote sensor)

The receiver detected an invalid packet that fails CRC

check

The receiver detected abnormal false tripping

Receiver detected unidentified packet that passes CRC

check

Thermostat failed to communicate with receiver module

Indoor remote sensor not responding (Indoor sensor is

enabled and thermostat has not received update for over

30 minutes) thermostat will display Fault and antenna icon

Outdoor remote sensor not responding (Outdoor sensor is

enabled and thermostat has not received update for over

30 minutes) thermostat will display Fault and antenna icon

Local sensor faulty

1 2 ... 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

White Rodgers 1F85RF-275 Guía de instalación Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos White Rodgers 1F85RF-275