White-rodgers 1F95W-80 Manual de usuario descargar pdf (Pagina 13)

13

position (see figure below). Remove the

battery for at least two minutes, to allow the

thermostat to reset itself. Replace the bat-

tery and put the thermostat back on the wall.

Press

SYSTEM

HEAT - OFF - COOL - AUTO

until the desired operating

mode is displayed.

EMR (ON)

Switch #1 set at installation (DO NOT CHANGE)

Switch #2 set at installation (DO NOT CHANGE)

Switch #3 ON

Switch #4 (see TOTAL KEYPAD LOCKOUT)

To disable EMR, press

SYSTEM

HEAT - OFF - COOL - AUTO

until OFF is

displayed. Remove the thermostat body

from the wall and use a pencil or small

screwdriver to move option switch #3 to the

OFF (down) position. Remove the battery

and allow at least two minutes for the ther-

mostat to reset itself. Replace the battery,

press

SYSTEM

HEAT - OFF - COOL - AUTO

until OFF is displayed, then

replace the thermostat on the wall. Press

SYSTEM

HEAT - OFF - COOL - AUTO

until the desired operating mode is

displayed.

• AUTOMATIC CHANGEOVER — If your

thermostat was configured for this option,

you can set the thermostat to automatically

switch the system from heating to cooling as

needed. Press

SYSTEM

HEAT - OFF - COOL - AUTO

to set the thermostat

to AUTO (the setpoint display is blank in the

AUTO mode). The system will now auto-

matically switch between heating and cool-

ing depending on the actual room tem-

perature.

ON

1234

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Comentarios a estos manuales

Sin comentarios